[PR]上記の広告は3ヶ月以上新規記事投稿のないブログに表示されています。新しい記事を書く事で広告が消えます。
[PR]上記の広告は3ヶ月以上新規記事投稿のないブログに表示されています。新しい記事を書く事で広告が消えます。
Have you ever wondered how to sanitise your Bottled or Bottle less (plumbed in / mains connected) Water Cooler? The following instructions are written for use with Aqua Dosa products. Suitable for use on all water coolers the following instructions treat all water lines, tanks and dispensing taps.
It is important to note that the following sanitisation process should be carried our every 3 months or sooner if there has been any known contamination of your water cooler or water machine. If your machine or cooler is left unused or left empty for a length of time then you should also sanitise the machine immediately before letting people dispense water from the machine.
If your water cooler is connected to the mains water supply then you must replace your filter every 6 months. If your filter is older than 6 months then it must be REMOVED from the machine to avoid Health and Safety concerns.
Why does Water Coolers Direct Ltd use Aqua Dosa products?
Aqua Dosa are winners of a Green Apple award for environmentally friendly products this is because the Aqua Dosa solution breaks down to oxygen and water and leaves no toxic products. Army green fashion simple long scarf
In addition to this the product has no taste or odour and kills bacteria including Legionella, viruses, algae, fungi and fungal spores and is completely environmentally friendly.
For Point Of Use / Plumbed in Coolers:
Shut off the water using your Shut Off Valve on the inlet pipe
Replace your coolers filter with the Mini Dosa using the push fit connectors. It is important the filter is REMOVED, as any carbon filter would make the sanitising solution ineffective.
Unscrew the see through container at the base of your Mini Dosa
Put 20ml of Sanitiser fluid into the container and refit to the Mini Dosa
Empty your coolers tank through the taps
Turn the water back on using the Shut Off Valve
Leave the machine for 10 minutes
While you are waiting clean your cooler with your Aqua Dosa Wipes
Shut off water
Empty your coolers tank through the taps
If you have a hot machine turn off the red hot switch and then drain the water through your hot tank drain (normally located at the base or back of your machine)
Turn on the water using your Shut Off Valve
If you have a hot machine leave for 5 minutes to ensure that the hot tank is full and turn on the red hot switch
Flush half a bucket of water through your taps to remove any remaining Sanitiser Fluid
Taste water to ensure quality
Your cooler is now ready to use
For Bottled Fed Coolers:
Remove the empty bottle from your machine
Remove the Spike Housing and the separator you will then see the tank
Using your Sanitiser Bottle pour 20ml of Sanitiser Fluid into the tank
Leave the machine for 10 minutes
While you are waiting clean your cooler with your Aqua Dosa Wipes paying attention to the Spike Housing and the separator
Empty your coolers tank through the taps
If you have a hot machine turn off the red hot switch and then drain the water through your hot tank drain (normally located at the base or back of your machine)
Replace the Spike Housing and the separator and place a full bottle on the machine
If you have a hot machine leave for 5 minutes to ensure that the hot tank is full and turn on the red hot switch
Leave the machine for 5 minutes to enable the coolers tank to fill up
Flush half a bucket of water through your taps to remove any remaining Sanitiser Fluid
Taste water to ensure quality
Your cooler is now ready to use
Direct Chill:
For Direct Chill Systems the procedures outlined above remain somewhat valid but we would advise you to contact your supplier for more detail.
Copyright © WaterCoolers Direct Ltd 2007
These instructions were written with the kind permission of Aqua Cure PLC makers of Aqua Dosa AquaDosa. Water Coolers Direct Ltd and Aqua Cure PLC offer this set of instructions as Guidance Only. Therefore, Water Coolers Direct Ltd and Aqua Cure PLC and its employees or representatives cannot be held responsible for any work carried out by YOU and/or ANY third party using the instructions either in writing or over the telephone via the HelpDesk.